|
Will I finish with Jig and will send it back to Ken to look over . What I found was two thing first the center bar was bent by over thigh ting the four screws that clamp the flat to the side plates when I got the Jig it had a 3/8 bow in the bar which was flatting my dip at the bottom by the mag well. I don’t how many flats were done you can over thigh need just enough to keep the flat from moving . Even so this bar needs to be check every five or six uses it still may move a little and need to be straighten. Also both side rails were bent at it weakest spot . I think this was from to much pressure going down possibly from a electric or air operated press I have a 12 ton press and I think it could bend it if I wasn’t careful it only needs to go down to the bottom till the bolts tough the bottom of the Jig no real pressure in needed to be seated. I have straighten all the bars and bent 15 flats seems to be working good.
:D
|
Hybrid Mode
