How to remove a Colt Sear Block - Quarterbore's Forums

		Quarterbore's Forums > Title 1 Weapons Forums > AR-15 Topics
How to remove a Colt Sear Block

02-20-2005, 12:58 PM

Typhoon

Junior Member

Join Date: Feb 2005

Posts: 17

How about the new colt sear blocks, where the block is actually part of the lower receiver mold? Just dremel it down to mil-spec?

Thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
300 Whisper AK - Just found a gas block that might be a good start...	Quarterbore	300 Whisper Rifles and Pistols	15	07-08-2006 10:46 AM
Gas block advice needed	Cornholio	300 Whisper Rifles and Pistols	4	08-29-2005 06:09 PM
Gas block posistion ?'s	Greywuuf	300 Whisper Rifles and Pistols	3	02-13-2005 12:02 PM
Replacing a Front Sight Base...	Quarterbore	AR-15 Topics	1	12-14-2004 08:01 PM
U.S. v. Kent	Quarterbore	Short Barreled Rifles	0	12-14-2004 07:37 PM

All times are GMT -4. The time now is 05:21 AM.

Quarterbore.Net Forums