Quarterbore.Net Forums

		Quarterbore's Forums > 300 Whisper Forums > 300 Whisper Ammo and Reloading
Brass Bending

Mark Forums Read

Prev

Previous Post

Next Post

Next

#6

Old

10-11-2007, 04:48 PM

redneckdan redneckdan is offline

redneckdan is offline

Junior Member

Join Date: Apr 2007

Posts: 29

Quote:

Originally Posted by jjmcrowell

The pipe cutter worked a lot faster than I thought and I was using a really old cutter. Thanks, I think I'll be using this quite a bit.

Just make sure you cut it as close to the neck as you can, it is possible to cut them too short. After a while you'll get a feel for how short to cut them and leave .005-.010" for clean up trimming.

Reply With Quote

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 05:33 AM.