Official Rent Quarterbore's DPH AK-47 Flat Bending Jig - Second Tour

[Quarterbore]

Originally Posted by Oldmanpaintball

This may be nothing but I am getting 20 thousandths worth of expanision on the jig when pressing. Should I be concerned?


OMP

20-thousandths .... Umm, how do you measure that.... this is an AK so I didn't think much other then headspace was measured with that much care....

[Oldmanpaintball]

LOL, are you saying that I am overly anal? How dare you! Actually I put a magnet mounted dial indicator to the base while I was pressing. I then too a OD of the jig before and after pressing.


I am sure it will work fine. I am just that crazy.


Matt

I am hoping to be done with it this sunday. Sorry for the wait but screws were a little tricky to find. I will post when done.




MAtt

[Wrangler]

You sort paintballs by weight too? Might be fun to find out how consistant they are.....useless but fun.

[ixtow]

Originally Posted by Quarterbore

20-thousandths .... Umm, how do you measure that.... this is an AK so I didn't think much other then headspace was measured with that much care....

Headspace +/- .25" should be fine, right? :-P

I knew I shoulda got matching number kits....

[coaldogie]

Bent the first flat today. After a lot of time I got it all the way down the jig only to find that I was off center. ( its a poor craftsman that blames his tools ) Darn tool so I am a poor craftsman. But we will do the other 4 Sat. afternoon. coaldogie

[ixtow]

Originally Posted by coaldogie

Bent the first flat today. After a lot of time I got it all the way down the jig only to find that I was off center. ( its a poor craftsman that blames his tools ) Darn tool so I am a poor craftsman. But we will do the other 4 Sat. afternoon. coaldogie

I noticed all my bends were off to the side by the same amount, but it's nowhere near enough to care. They all work fine... ;-) It is the tool. But it's within AK tollerance. You know, +/- half an inch.

[Oldmanpaintball]

Well crap. Bent my second flat today and remeasured it again. Something didnt look right so I took a close look at the jig, the little bars in the bottom of the jig are not in the best of shape. The welds holding the front one are almost cracked all the way around and the rear is on the way. I can re-weld it in but It will take me a couple days to get it done. I still have 3 flats to go!

Quaterbore whats your feeling?


Matt

[Quarterbore]

I would appreciate it if you can weld them back up.

The bars on the bottom are really only there to indicate that the jig are deep enough. There is no need to apply any pressure to that point and the receivers should be fine even if you don't actually hit them...

I think the first jig got bent when people over pressed the jig... it just isn't necessary to squash that....

[ShuckersFan]

Originally Posted by Quarterbore

- Will be getting Jig #1 from coaldogie

Yeah, I'm next!!! Any tips or jig quirks you might want to share coaldogie?

[Oldmanpaintball]

I am hoping that you meant .025 rather than .25...lol.


Matt