|
I did get the drive screws... thanks! I also have no problems with you tacking the pins if you are sure but you have to be careful not to build up the material of the flat will not sit flush to the bottom plate and it will bend the bottom of the receivers out.
I think I would rather epoxy or a hi-strength loc-tite myself as these pins are only to center the flat... there is no requrement for strength there and the only worry would be that the pins get lost.
As for the other jig, I got hit hard at work with a short notice project and I have not had time to bend up a flat and test the other jig. I hope this weekend I can do it...
The jig body that looks like it is bent has about a 1/8-inch bow to it... I have not took photos yet as every night this week I got home well past dark.
I also got another pelican case so if my first DPH jig with the bottom plate from my second jig will work (I assume it will) I will be able to ship this jig out. I hope that I can get it out on Monday but I really don't want to ship until I am sure it is working correctly...
|
Hybrid Mode
