Quarterbore.Net Forums

Oldmanpaintball · #1 03-23-2006, 02:53 PM

If the center section is actually bent it may be garbage. You cant mill the base falt again because that would change the distance from the bottom of the receiver to the top rail bends. Send me some pics and I will tell you if I can fix it. As for steel, I planed on milling down what was needed anyway.

my email

armadillo@turbonet.com

Thanks

Matt

mondtster · #2 03-24-2006, 05:56 PM

OK guys, the jig is going out today via UPS. The tracking number is as follows:

1z5716350345677839

This is going UPS ground so I would expect it to arrive late next week. Thanks again Quarterbore!

d.hauser · #3 03-25-2006, 02:31 AM

yea!!!!!!!!!

ShuckersFan · #4 03-25-2006, 04:47 PM

Hey, was looking to buy a jig and I came accross your forum... Can I still get in on this jig rental?

Thanks!

Quarterbore · #5 03-25-2006, 05:37 PM

Quote:

Originally Posted by ShuckersFan

Hey, was looking to buy a jig and I came accross your forum... Can I still get in on this jig rental?

Thanks!

Sure can! If you decide you want to buy one sluggerman here on the forums is making an excellent 555th jig and selling them:

http://www.quarterbore.net/forums/showthread.php?t=682

I will add you to the list but if you change your mind just let me know...

Oldmanpaintball · #6 03-26-2006, 08:28 PM

Any luck getting those pics out or the jig boxed up?

Matt

d.hauser · #7 03-31-2006, 01:58 AM

received jig on 3-30, everything looks ok, i will tig weld the locator pins back in if there is no problems with me doing that. i will also replace the washers that go under the caphead screws, they are pretty messed up.

i will let you know just before i am done with it, to get next persons address.

thanks again...........

ps.
did you get the drive screws yet ken?