Upon Reciving the jig shipping and packing was in tact . Jig did not look damaged.
However the plate with the locating pins sits off center on one end. It is off on the front trunnion side. When you have all the screws in except that one you can see the hole does not line up with the threaded hole , so when you tighten that screw it pulls it to the side a little.
I bent one you could see it was off by the holes on the bottom (paper weight)
ie. mag hole
we had to drill the front pin hole on the flat bigger so we could get it to set in the jig on center, then we were able to get one bent on center