Paladin Machine barrel for sale

[Texdoug1]

On to another project. I'm selling my 16 1/2in barrel with the Paladin adjustable gas block and tube installed. It has been Duracoated OD Green, and it might have a couple scratches under the handguard where I had to put it in a vice. It shoots great. I did open up the M4 feed ramps a bit in an attempt to get it to feed RN bullets, with no luck. The end result was less marking up of the bullet and brass trying to squeeze them through the 5.56 ramps. I've had about 400rds through it all subsonic. shoots about 1moa with 208 Amax and 8.1gr lil'gun. $200 shipped

[Spanners]

Keen

Pic pls?

[Texdoug1]

I'll try to get pics tomorrow

[Spanners]

Thanks
Matt

[L1A1Rocker]

"M-4 feed ramps"? Is this just a barrel or an upper (if upper what all comes with)? Where is the gas port location, what size, and is there a chamber guage? Also, what is the twist?

Thanks, looking forward to the pics.

Edit for one more question. Do you know if the chamber was cut with a Clymer (40) or a PTG (35) reamer, and how the difference will relate to 300 BLK converison, if any?

[Texdoug1]

Originally Posted by L1A1Rocker

"M-4 feed ramps"? Is this just a barrel or an upper (if upper what all comes with)? Where is the gas port location, what size, and is there a chamber guage? Also, what is the twist?

Thanks, looking forward to the pics.

Edit for one more question. Do you know if the chamber was cut with a Clymer (40) or a PTG (35) reamer, and how the difference will relate to 300 BLK converison, if any?

It's just the barrel, gas block, and tube. Port in pistol position. No chamber guage. The rest is standard Paladin Machine, so I don't remember. I just know it shoots great.

[Texdoug1]

Got some pics. I did notice it has a few minor scratches in the duracoat, as you can see in the pics nothing major. barrel is threaded 1/2X28.

http://i158.photobucket.com/albums/t89/texdoug1/055.jpg
http://i158.photobucket.com/albums/t89/texdoug1/054.jpg
http://i158.photobucket.com/albums/t89/texdoug1/049.jpg

[tp555]

Looks like a 5/8 thread on the end.

[Spanners]

SOLD - will be in touch tomorrow

[Texdoug1]

Your right TP, you should know you made it. Sorry for the brain fart.
On a side note thanks, its been a great barrel.