I used the jig tonight to bend a flat and the jig does a really nice job. I took 140 pics of the process and tools and it will take me some time to go through the files and pick the best and most important pics and cut down the images to a reasonable size and add text... I will try to get this done as soon as possible. The files at this point take up 118MB of disk space!
Following is a photo of the tools that I will be shipping:
Note:
DPH Flat Bending Jig
One LONG Piece of Steel to be used BETWEEN Press arm and Jig
One Short Piece of Steel to be used between jig and hammer when poping jig out of form after bending flat
1 4mm Allen Wrench
1 5mm Allen Wrench
Can of all purpose grease and small brush to apply it with
(Note I will not be shipping my 12-ton press so you will need one to use the jig!)
I have uploaded a bunch of pics of the flat I bent tonight including some side by side pics of my new bent flat next to a 100% OOW receiver that I own. You can browse thos pictures here:
http://www.quarterbore.com/dph-jig-01/