Turning a Toroid - Quarterbore's Forums

		Quarterbore's Forums > Tool Topics > General Wood Lathe Topics
Turning a Toroid

11-17-2010, 12:58 AM

gjk

Junior Member

Join Date: Nov 2010

Posts: 2

Turning a Toroid

Hello,

Being new to these forums and the wood lathe, I was wondering if anyone had any tips on turning a torus.
I searched the internet for tutorials on turning a wooden torus but could only find metal spinning information.

Any info on how to spin a wooden torus or what type of wood to use would be greatly appreciated :)

Last edited by gjk; 11-17-2010 at 01:00 AM.

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 11:03 PM.

Quarterbore.Net Forums