Dillon casefeeder and .300 Whisper

[Garrett]

While I currently load .300 Whisper on a single-stage press, I would eventually like to set up a toolhead to use on the Dillon 650.

I had tried using the small rifle tray in the case feeder. The way it is set up, cases like a .223 will always drop into the tube base down. However, the shorter .300 Whisper case will fall into the tube either up or down, depending on how it aligns in the casefeeder plate.

Anyone set up to load .300 W on a 650? Did you have to modify the casefeeder plate, and if so, what did you do?