Wiring help needed! - Quarterbore's Forums

		Quarterbore's Forums > Tool Topics > General Metal Lathe Discusions
Wiring help needed!

10-01-2008, 11:11 AM

10shotgroup 10shotgroup is offline

Junior Member

Join Date: Oct 2008

Posts: 2

Wiring help needed!

I have a Clausing im trying to set up to run on a rotary phase converter. Im trying to swap the lathe to low voltage, but none of the wires are identifiable. the only wires i can identify are t1 t2 t3 because those are obviously my lines. Any help on identifying these wires would help.

Last edited by 10shotgroup; 10-01-2008 at 11:28 AM.

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 05:55 AM.

Quarterbore.Net Forums