Wiring help needed!
 

I have a Clausing im trying to set up to run on a rotary phase converter. Im trying to swap the lathe to low voltage, but none of the wires are identifiable. the only wires i can identify are t1 t2 t3 because those are obviously my lines. Any help on identifying these wires would help.

http://i155.photobucket.com/albums/s...lathe001-1.jpg

Call Clausing in Kalamazoo michigan and get an owners manual or just ask them they are very nice people.

Good luck

wiring
 

i have all the original manuals. the problem is that the original labeling of the wires has worn off. I need a way to identify the 6 remaining wires ( t4, t5, t6, t7, t8, t9,) for rewiring from high to low voltage.

i have t4 and t7 identified, so that leaves me with (4) unknown wires.