Building AK receivers from a Tapco Flat using a 555th Flat Bending Jig

		Quarterbore's Forums > Title 1 Weapons Forums > AK-47 Topics
Building AK receivers from a Tapco Flat using a 555th Flat Bending Jig

#12

04-03-2005, 09:37 PM

Quarterbore Quarterbore is offline

Administrator

Join Date: Dec 2004

Location: Valley Forge, PA

Posts: 1,598

Honestly, I would like to but that is way too far into the future for me to say if I can go or not...

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Official Rent Quarterbore's DPH AK-47 Flat Bending Jig - Second Tour	Quarterbore	AK-47 Topics	260	06-10-2006 04:14 PM
The official RENT QB's AK-47 Flat bending jig thread (Tapco Flats to Receiver)	Quarterbore	AK-47 Topics	116	08-06-2005 08:59 PM
Question about the flat bending jig	prebancolt	AK-47 Topics	7	07-07-2005 05:22 PM

All times are GMT -4. The time now is 10:57 PM.

Quarterbore.Net Forums