Quarterbore.Net Forums

		Quarterbore's Forums > Title 1 Weapons Forums > AK-47 Topics
Building AK receivers from a Tapco Flat using a 555th Flat Bending Jig

Mark Forums Read

Reply

Page 2 of 2

2

#11

Old

04-03-2005, 04:14 PM

gcollector2002 gcollector2002 is offline

gcollector2002 is offline

Junior Member

Join Date: Feb 2005

Posts: 18

Gun Show

QB

There is a gun show:

King of Prussia Pennsylvania: Valley Forge Gun Show - Valley Forge Convention Center - Jun 18-19 2005 610-975-0877

Are you going?

Thomas

Reply With Quote

#12

Old

04-03-2005, 09:37 PM

Quarterbore Quarterbore is offline

Quarterbore is offline

Administrator

Join Date: Dec 2004

Location: Valley Forge, PA

Posts: 1,598

Honestly, I would like to but that is way too far into the future for me to say if I can go or not...

Reply With Quote

Reply

Page 2 of 2

2

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Official Rent Quarterbore's DPH AK-47 Flat Bending Jig - Second Tour	Quarterbore	AK-47 Topics	260	06-10-2006 04:14 PM
The official RENT QB's AK-47 Flat bending jig thread (Tapco Flats to Receiver)	Quarterbore	AK-47 Topics	116	08-06-2005 08:59 PM
Question about the flat bending jig	prebancolt	AK-47 Topics	7	07-07-2005 05:22 PM

All times are GMT -4. The time now is 10:15 AM.