Fired my 300 whisper for the 1st time today.

[Cornholio]

I wouldn't bother with the Trailboss. I'd try Red Dot, if you have any on hand. Six and a half grains should put you in the ballpark with the 165 and 190 gr bullets.

[amafrank]

You need to post some pictures of that rifle. I just bought a Sako action that is made for .222 I think and I can't figure out what model it is....its single shot and going by pics on gunbroker and other sites its either an L46 or an L461 I think.
Its going to be a .300-221 when I'm done but it sure would help find stocks and scope mounts if I knew what model I'm dealing with. I've heard good things about the Sako's and I'm looking forward to getting this one up and running. I'll post a pic of the action once it ships in.

As for quieting down your rifle, I think CH is right. You need a faster powder to make sure pressures and temps have dropped before the bullet exits the barrel. Kind of like shooting .22 LR out of a pistol than a rifle. The rifle is quieter due to lower pressure and temp gasses coming out the muzzle end. Somewhere in there is a happy medium that will have minimum pressures at the muzzle but still get proper subsonic velocity. If you go too fast on the powder you will end up needing too great a charge weight to get the bullet past the drag of the longer barrel.
Make sure you keep track of whether the bullet actually exited the barrel. Its not as hard to stick one in the barrel as you might imagine. I stuck a 147gr tracer in a remington 799 with a 16" barrel using 7.2 gr of H110. Tracers have a long bearing surface so data for the 150gr slugs was not quite enough to overcome the greater drag. I also stuck a 240gr SMK in a 9" SIG 552-300 barrel with 8gr of 4198. This load worked great in the 799 with the longer barrel but I think the gasport in the 552 dumped too much pressure and the drag of the long bullet was too much.

hope that helps
Frank

[Jeff_8]

I also own a Sako L461 in 300 Whisper, it was a 17 Rem. Had it for more than a year now but only used it in the field once. I found that the Sierra 220 grain match kings no good on small and medium game at both sub and super speed, they didn t open up at all. I also tried a supersonic load of 110 grain V-Max with 18 grains of AR2205 and it killed like lightning and was accurate, but it was loud and not what I built the rifle for. I bought a box of Woodleigh 240 grainers at the Sydney SHOT show and will be going away today, hopefully to test them.

Jeff

[cr500]

amafrank. The Sako L461 rifles I have seen have not been single shot. Mine will hold 7 cases in the mag, which is one of the reasons they are popular. I dont know what the single shot Sako would be.
I,m off to the local gunshop now to see what faster powders they have.

[amafrank]

Thanks for the info on the L461....I'm leaning toward the L46 as the best possibility.

We did some informal waterjug testing a couple weeks back and were pretty disappointed with the 240gr and 220gr results. Both of them tended to split the jug but not much and just punched through the whole thing. Sometimes you couldn't even tell you hit the jug....I loaded up some 130gr speer flat points made for 30-30 to take on this adventure too. They blew the jugs up in a most spectacular fashion. I think for hunting use the light bullets are probably the best bet and loaded up to supersonic velocity. Accuracy seems to be fine with the lightweights even with the 1-7.5" twist. The heavy slugs seem to have a niche in the harder targets area. Things like knocking down silhouettes and ringing targets at longer ranges. We tested a rifle and suppressor by firing into an unoccupied forest area. When we looked at the impacts on the trees we discovered that at 200+ yds the 220s and 240s were going through the 8in diameter walnuts and hackberry trees. Maybe thats simple for a rifle but for a subsonic slug to do that its pretty impressive. 9mm luger won't go through one of those trees at 50ft....
In many states you can't hunt with a suppressor so the versatility of the round is a great advantage.
just my opinion of course.

Frank

[Jeff_8]

My Sako only will fit 6 rounds in the magazine. I went away yesterday but only got to shoot rabbits, the 110 grain V-Max was OK, similar to 30 grain V-Max out of the 222, big holes. There wasn t anything bigger to shoot and I should have used the Whisper for the lot as I had trouble with the 222 and 22, and its quieter than the 222 even with supersonics.

cr500, who built your rifle?

Jeff

[cr500]

Jeff 8. The person who built my rifle is on this forum as spmorgan. He did a good job and it looks good.

I will probably work up 3 loads for my rifle. I will make up a subsonic load with 240gn bullets for when I want to keep the noise down. I cant use a suppressor here, but I can at least make it quieter than regular centerfires. My other loads will be 125 BTs for pigs, goats etc and 110gn Vmax for rabbits, foxes etc. Should be pretty versatile. Main thing is I want it to have low recoil and short length so my wife can use it. Low muzzle blast will not scare her as much as well.

[Jeff_8]

Originally Posted by amafrank

You need to post some pictures of that rifle. Frank

Frank,

I thought you might like to see this one.

http://www.quarterbore.net/forums/ph...ry.php?cat=574

[amafrank]

Thanks Jeff,
That helps a lot. I'd say my action is definately not an L461. Its supposed to be on the UPS truck for delivery today so I'll post some pics tonight if it makes it.

Looks like you've got a good bunny face remover there too.

Frank

[amafrank]

Here are side and top views of the single shot Sako action. Any help in identification is appreciated. I need to find a stock and scope mounts for this baby and its nice to know what model ...








Thanks guys

Frank