|
well, I'm not sure if this is going to help at all. I don't have any precision measuring equipment for such a small hole. The best I could think to do is use drill bits and see what would fit in the hole. Here is my findings.
3/32 bit wouldn't fit, but it was damn close. (3/32 = .09375)
5/64 would fit with room to spare. (5/64 = .07812)
So I tried to do some math to see what the middle point is and I came up with .08593. So I guess the best guess I could make is that its near .086" but seems closer to .090"
|
Threaded Mode