308 subsonic

[Foxfire]

Artful,

Are you still using reduced capacity cases?
Or have you gone back to using stock cases?

TIA, Foxfire

[Artful]

Back to stock cases as both the epoxy and the thermal polymer failed to hold up inside and broke up sending chunks down the bore into the suppressor.

If you want to use reduced capacity cases I'd suggest you either look at the aluminum ones from Canada or the brass ones from Europe but either way it's not cheap - I'm going back over my results trying to find my errors as at this point I should have found what I was looking for but may have to rethink my parameters for what I want out of my load.

[Foxfire]

Find out your errors???....
I thought you had a very good load (7.9 clays), that is why I was asking about the cases.
What are you trying to get out of it?

Fox

[Artful]

Foxfire 7.9 of clays isn't a bad load it just isn't always subsonic out of my gun
- I need a load that is always quiet and accurate - last test I did which I didn't really put out was loaded with clays in lessor amounts

7.9 gave
1149
1140
1168
1192
1189
1186
1134
1147

7.8 gave
1018
1129
1126
1129
1139
1153
1240
and one missed one of the screens?

7.7
971.8
1120
1115
1126
1149
1152
1127
1152

still too fast and I don't want to go below 7.7 due to volume concerns.

Now keep in mind these are thru a 21" barrel so any of these may work very well in your barrel. You just have to try it and see.