Cast

[kogashuko]

http://www.leeprecision.com/cgi/cata...ml#CUSTOMMOLDS

"Molds
We make custom bullet molds to your specifications. Maximum bullet mold dimensions for standard mold blocks; (all dimensions in inches) single cavity, .580 diameter, 1.250 length; double cavity, .685* diameter, .900 length; six cavity, .520 diameter, 1.000 length; *for single cavity mold in double cavity blocks, like our slug mold. For two cavities in the double cavity blocks, max. diameter is .600 inch. Click here for a mold design assistance sheet.

We need:

Payment ($100 set-up and tooling fee for flat based bullets plus the cost of the mold ) ($150 for hollow based bullets, plus the cost of the mold)
Single or double cavity molds would be $24.98 each, six cavity would be $50.00 each. Hollow base bullets can only be made in single cavity, and are $25.98 each.
Add $4.00 to your order for order processing fee
The above set-up and tooling fee will be waived on orders of 25 pieces or more. For orders over 100 pieces regular dealer/distributor prices apply to mold prices, in addition to elimination of the set-up and tooling fee."

[gary0529]

redneckdan,

Your posting concerning how dirty the H-335 burned mirrored my experience.
Tried it behind 200 grain cast spire point/GC and the accuracy was OK-getting under 1" @ 100 yards with bolt action Rem XR , 16" Lilja SS 1/8 barrel and Gemtech can but dirty. After 15 or so rounds I had unburned powder building up and was necessary to take an AR type brush to clean out crud from action.

On a positive note, noted very little to no leading in suppressor or in barrel.

Nice to shoot cheaper home cast than Sierra 240's .

Have yet to try Lil Gun or VV-110 but may have to swing by local shop and see if either in stock and not outrageously expensive.

Gary

[HUNTER2]

Has anyone retrieved any of the spent bullets to see if the lube is actually doing anything. Shoot .308 45 430 510 cast subsonic. All of the bullets I recover from an oak backstop has all of the lube still intact. Different manuf. but all the same....Not going fast enough for lube to work? Have started using plain cast and they work just as well....