RLL in a Stag Rcvr?

[FontanaHorseman]

I am curious about "Plan B" and thought about the problem listed above getting the link out of the cut.

Has anyone worked something out???

Thanks, FH

[FontanaHorseman]

Also on cntrailriders mods to Stag receiver:

I did the same thing and it works fine with one caveat...if you use the RLL protector you will have to mill the lower deck down to .630 or the link will bind.

I am in the process of doing that with a dremel using different cutting heads and it is working fine.

After I test I will post back here but I see no reason it will not work, just takes a little time to do the cuts but you can do it without a lathe/mill.

YMMV, FH

[cntrailrider]

On 'Plan B' - I understand it, and I tried it, and get this......

When the selector is on F/A, it's semi

When the selector is on Semi, it's F/A



Nor can I get it to function reliably, even in it's 'backwards condition'. Obviously something in there isn't working right. When it's apart, the selector will lower and (with some fidgeting) raise the link, as intended. I am confounded.

I wish I had a plastic window in my lower, so I could see what's going on in there when it's together

OK you guys can stop laughing now....

I believe someone's going to figure out 'plan B' and eventually it may be me. That sure would be a feeling of accomplishment

Steve in EL Paso

[FontanaHorseman]

Originally Posted by cntrailrider

I wish I had a plastic window in my lower, so I could see what's going on in there when it's together when it's together

OK you guys can stop laughing now....

Steve in EL Paso

Not laughing - wished the same think myself many times!
FH