Quote:
|
Originally Posted by BJahn
I finally got authorization from my local electrical service provider (PG&E) to increase the electric panel size for my home, so I'm temporarily hooking my old Bridgeport 2J into my home clothes dryer circuit via my cheap 1-3 phase converter.
When first turning the switch to my mill, I only got a hum from the motor.
Can anyone put names on the four color wires coming from my mill so I can re-connect for better success?
Bruce Jahn in Northern California
|
This may or may not help but.....
Without knowing anything about what you have, if the motor on the mill is 240v 3 phase, you should have three motor leads and one ground wire. It shouldn't matter which way you hook up the motor leads; the worst that will happen is that the motor will spin backwards. If that happens, switch any two of the leads.
Someone else chime in on the humming.......
J
Threaded Mode