Which Seater Die For New Barnes 110 gr TAC-TX?

[Scoop]

Which brand seater dies have a deep enough space to seat the new 110 gr Barnes TAC-TX's without pressing on the plastic tip? I have Redding dies now and though I can't see where the plastic tip is being bent, I am having terrible runout problems. You can spin-test the loaded rounds and see the tip wobble around center.

[3006mv]

send me one and i will try in the Hornady new dimension die.
you should maybe try these out anyway if you buy a 2 die set before the end of the year they have an offer for free 100 jacketed bullets (of their selection you choose cal. , limited) Their die is marked .300 Whisper/ 300Blk

[Scoop]

Thanks for the offer. I have it figured out I think. It is the projectiles. Will have to contact Barnes. I drilled the hole in my seater plug deeper so there is no chance of contact and still have the same issue. Also tried a Hornady ND .308 seater die screwed all the way in and ended up with the same problem. 30% of the loaded rounds are good, 30% are terrible, and 40% are somewhere in between.