Needed a chainsaw carb gasket now on Sunday afternoon
So i fired up my lathe and chucked up a chunk of round scrap that i keep for small projects. It needed to have a 1 1/8" hole punched in the gasket. So i turned the chunk to 1 1/8" OD then turned the compound and cut from the center out making a nice sharp edge for the cutter. I left a small bump in the center of the punch to line up with the punch mark that i made with an ice pick down thru the diaphram cover. Just lined up the punch mark and slid everything in my shop press and punched it out. Perfect. 5 minute job....Bob
|
Threaded Mode