Needed a chainsaw carb gasket now on Sunday afternoon
 

So i fired up my lathe and chucked up a chunk of round scrap that i keep for small projects. It needed to have a 1 1/8" hole punched in the gasket. So i turned the chunk to 1 1/8" OD then turned the compound and cut from the center out making a nice sharp edge for the cutter. I left a small bump in the center of the punch to line up with the punch mark that i made with an ice pick down thru the diaphram cover. Just lined up the punch mark and slid everything in my shop press and punched it out. Perfect. 5 minute job....Bob

Cheater.

:grin:

I would have used a Sharpie marker and a razor blade. I know, I'm a cretan.

I have about 500 slugs of metal that i didn't know what to do with and didn't want to throw away for scrap. So i am going to make a few sets of hole punches for friends and family LOL...Bob