|
Hoser
I wondered if you can help me with a problem I am having forming 300 whisper brass with the CH4D trim die. The problem is that my brass "chips" are not curls or chips, rather they are long strings of brass which quickly bind around the shaft of the trimmer.
The method I use to get actual chips to form is to give a very high feed rate so that curling is induced and the brass breaks into chips. I'm nervous about this. I would rather go slower than faster.
Can you tell me more about your feed rate or method to produce the proper chips?
Finally, can you elaborate on the issues that result in a burnt out motor and give me some pointers on how to avoid burning mine out?
Thank you very much for your attention to my questions.
jonblack
|
Threaded Mode