new mvp from mossberg

[sha-ul]

Originally Posted by Spook

Ya know If someone could figure out a way to set a Sako extractor in the center of that right (bottom)bolt lug...it might actually keep the case on the bolt face through the extraction phase.

Actually, on my savage build, by swapping the extractor detent to a larger ball, it will hold the brass until it clears the port.

At this point, this is a far as I have got, since the loading bench isn't setup yet& I haven't picked up any loaded ammo.

[Mike Bell]

I sent Mossberg a message asking them to chamber it in the 300 Blackout........

[d-mon]

To small market for them. Maybe you would see the same rifle in 204 ruger but that would be about it for that size of action.
Nd

[thehouseproduct]

One of these set up as a switch barrel between 223, 20 practical and 300wtf would be epic.

[Mike Bell]

http://www.rifleshootermag.com/blog/?p=222



The MVP's Drop Push bolt employs a lever that drops down to catch cartridges in an AR magazine and feed them. The lever simply lifts back into the bolt face when the bolt reaches the feed ramp.