new mvp from mossberg

[skippy]

That thing looks sweet!!...wonder if they are out yet?

[Spook]

hmmmm ....where have I seen than bolt head arrangement before

[sha-ul]

Originally Posted by Spook

hmmmm ....where have I seen than bolt head arrangement before

ssshhh don't question it, that would be savage of you

[Spook]

Originally Posted by sha-ul

ssshhh don't question it, that would be savage of you

Ya know If someone could figure out a way to set a Sako extractor in the center of that right (bottom)bolt lug...it might actually keep the case on the bolt face through the extraction phase.

[d-mon]

Hi spook,
what about having a sako type extractor on the top of the right lug?
Wouldn't that work?
I have not seen the configuration of the bolt head on that modsberg.
Nd

[sha-ul]

Originally Posted by Spook

Ya know If someone could figure out a way to set a Sako extractor in the center of that right (bottom)bolt lug...it might actually keep the case on the bolt face through the extraction phase.

Actually, on my savage build, by swapping the extractor detent to a larger ball, it will hold the brass until it clears the port.

At this point, this is a far as I have got, since the loading bench isn't setup yet& I haven't picked up any loaded ammo.

[Mike Bell]

I sent Mossberg a message asking them to chamber it in the 300 Blackout........

[d-mon]

To small market for them. Maybe you would see the same rifle in 204 ruger but that would be about it for that size of action.
Nd