Gemtech Tundra 9MM Suppressor

[mak91]

I have a bowers 9mm that I have used with subsonic loads that sounds about the same as my aac 7.62 can with subs. 9mm cans should not be used with non subsonic loads. If you rapid fire even with subsonics you could cause heating damage if the can is aluminum and some say not to use them with the 300wtf. So some use then some don't but if your question is does it suppress the sound my experience is that they do just about as well as a 7.62 can.

[milehipo]

Thank you. Any sub loads for a 18" Pacnor barrel bolt rifle?

[glocker17]

It will work great on a bolt gun. You can shoot as fast as you want with a bolt, you will not be able to get it real hot with subs.

I prefer my swr trident to my Omega 300.

Blake

[milehipo]

The powders I have are 1680,#9, Viht 110. The bullets I have are 175 and 220 gr.
Thank-You for the assistance.

[Spook]

Originally Posted by milehipo

Thank you. Any sub loads for a 18" Pacnor barrel bolt rifle?

curious, why 18 as opposed to 16 ?

[milehipo]

You know I dont recall why it was built at 18".

[jimpa]

I am using the 9mm Trident on my 300/221 It does the job right, is small, and looks great on the CZ action

[milehipo]

Originally Posted by jimpa

I am using the 9mm Trident on my 300/221 It does the job right, is small, and looks great on the CZ action

Would you mind sharing your sub-sonic loads for this rifle?

[milehipo]

Ok I have Nikon Monarch 4.5-14 Mildot on the CZ rifle. Went to range this morning using Viht 110 9.6 and 220 gr Sierra HPBT. Seemed to group ok at 100 yards but I ran out of adjustments by about 5-6" to center target. Windage seems to have enough adjustments left. If anyone knows the best way to get the scope with more adjustments please advise.
I dont know if its a matter of winding the adjustment to half way center then shim and rezero??