Quote:
|
Originally Posted by Greywuuf
Quarterbore... I think the point being made was this... if you solder a US made muzzle device onto an imported barrel... it no longer counts as a US part... because it is now actually the barrel... and the barrel is imported. You have merely modified an imported part.
maybe I am reading the intent of the post wrong.... but it is a valid point.
|
Correct in my OPPINION... The muzzle attachment is now part of the imported barrel...
Quote:
|
Originally Posted by aloharover
For my part, the question is:
If I weld two imported parts together is it now one imported part?
:)
Pete
|
As I said above, yes, this is my OPPINION!
If this was not the case and you use the AMD-65 as an example, the muzzle attachment that we silver solder, weld, or blind pin on the barrel has to be part of teh barrel or you would only have a 12.5-inch barrel and it would be a Short barreled Rifle. By using these methods the muzzle attachment is part of the barrel and you no longer have a SBR...
Yes, the barrel is still an imported part as otherwise I could just slap a spot of weld on any parts and declare it was made in the US. In this case you are simply making one part part of another...
Threaded Mode