Thanks for updating this for me... For those that d not know my brother suffered a home invasion and details are here:
http://www.quarterbore.net/forums/fo...play.php?f=133
It has been a long couple weeks but a group of guys came out this past weekend and helped finish up some projects for my Brother and his family but it is still going to be a long hall.
I spent some time last week looking at what the problem was and it looks like the alignment pins were mounted off center just a little. I didn't notice when I bent my flat but it was a new jig and I only bent one with it before sending it out. With use the bin that was improperly located simply bent the steel around the pin until it finally worked it's way free.
I have two DPH jigs and I am going to spend some time tonight getting my other jig marked up like I did to the other jig and I will just send my other jig out. I wasn't originally going to do this but it looks like I am going to need to make a new bottom plate for the jig that is damaged and the locations of those holes are critical.
The biggest issue now is I need to make up a huge number of hours at work or I don't get paid and my wife is starting to lose patience with all my time distractions as well...
So, I need to stamp the other jig to make it clear that people hould not press directly on the jig, plus I am going to build a smaller shipping box to reduce the shipping costs, and then I will try to get this shipped tomorrow (Oct-18th).
Sorry for the huge delay...
Linear Mode
