Best Way To Make .300 Whisper Brass From .223 Hands Down!!!

[jonblack]

no4mk1t

Thanks for the reply. I appreciate the information and assistance. I have a casefeeder for my XL650 so I would really like to use it for some volume work. I am guessing I need to machine the top of the Dillon toolhead to allow the RL-1200 and C-H trim to die extend lower to the shell plate. Is that correct?

If so, do I need to machine the entire tool head or just "relieve" an area large enough to allow the RL-1200 and vacuum port to clear?

I will have to look at the tool head and see if it would just be easier to make a special one from aluminum just for this task.

Thanks again for any assistance you can provide.

jonblack