Quarterbore.Net Forums


Go Back   Quarterbore's Forums > 300 Whisper Forums > 300 Whisper Ammo and Reloading
Home Forums Classifieds Photo Server FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #13  
Old 09-28-2009, 01:45 AM
Casey Casey is offline
Junior Member
 
Join Date: Feb 2009
Posts: 3
I took a simple drill press vise and with the jaws tight drilled a hole in the middle just the right size to hold the case tight. Spinning a 1/2 end-mill at 2000 rpm eats them right up. Repeatability is within .003" and it cuts faster than the mill in the video. I do run them through my wilson trimmer after the final sizing to make sure everything is square. I don't make a lot of brass but I sized, cut, and trimmed 100 cases in a few hours, good enough for me.
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:44 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2016, Jelsoft Enterprises Ltd.