Question about the flat bending jig

		Quarterbore's Forums > Title 1 Weapons Forums > AK-47 Topics
Question about the flat bending jig

06-28-2005, 07:28 PM

prebancolt prebancolt is offline

Member

Join Date: Jun 2005

Posts: 49

Question about the flat bending jig

QB,

I decided to try and build my own jig from the 555th jig print. I'm almost finished but I have one question:

What is the dimension of the opening that the block/flat is pushed down into. I measured the flat, it's about 0.040' (x 2) plus the 1.25 center = 1.330'. How much clearance total is needed to get a good bend?

Thanks!

J

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
AK Flat Bending Jig For Sale	smittygj	Gun Parts and Accessories	15	08-11-2007 05:30 PM
Official Rent Quarterbore's DPH AK-47 Flat Bending Jig - Second Tour	Quarterbore	AK-47 Topics	260	06-10-2006 04:14 PM
How to add your own Trivia Question - Please Read!	Quarterbore	Knife Trivia Forums	0	12-29-2005 10:38 AM
The official RENT QB's AK-47 Flat bending jig thread (Tapco Flats to Receiver)	Quarterbore	AK-47 Topics	116	08-06-2005 08:59 PM
Building AK receivers from a Tapco Flat using a 555th Flat Bending Jig	Quarterbore	AK-47 Topics	11	04-03-2005 09:37 PM

All times are GMT -4. The time now is 01:51 AM.

Quarterbore.Net Forums