I got the following in an e-mail and I need to update the page in the library at Quarterbore.com...
Quote:
Hello Ken,
There is a problem with your article on adjusting the Remington 700 trigger that needs clarification. I am a professional mechanic with over twenty years experience. In the second paragraph it says, "I normally run the screws in and out a couple of times to make sure that the screw is not binding and the surfaces are completely covered in oil". Caution must be used with the over travel screw because if you run it out, a tiny spring will drop down blocking and jamming the screw, which I did and it cost me a new trigger!
Otherwise a good article and since then I have adjusted several 700 triggers successfully.
Will
|
Threaded Mode
