Gas port Diameter - Quarterbore's Forums

		Quarterbore's Forums > 300 Whisper Forums > 300 Whisper Rifles and Pistols
Gas port Diameter

06-14-2005, 04:01 PM

Gos

Junior Member

Join Date: Mar 2005

Posts: 17

I started out with .076" since I figured that it's always easier to make the hole bigger than smaller. After some loading development, I opened things up to .086". Everything cycles just fine at that diameter without the action getting that "slamming" feeling.

Gos.

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Starting a New FAQ on silencers... Compiling notes...	Quarterbore	Silencers	5	04-18-2006 07:45 PM
I need a favor	Greywuuf	AR-15 Topics	7	12-22-2005 05:56 PM
Gas Port Diameter and SubSonic Loads. . .	dlt223	300 Whisper Ammo and Reloading	2	12-04-2005 02:35 AM
Possible to bore 10mm (OD) stock to a depth of 1 inch with a hole diameter of 8mm?	Cobra	General Metal Lathe Discusions	4	07-01-2005 10:06 PM
Gas block posistion ?'s	Greywuuf	300 Whisper Rifles and Pistols	3	02-13-2005 12:02 PM

All times are GMT -4. The time now is 04:01 AM.

Quarterbore.Net Forums