|
Hey everyone,
I bent two flats yesterday following the directions under the jig rental post and I'm not sure if the outcome is good enough to use to build a parts kit rifle. You will notice that the top bend (done with hammer) are not even and that my first flat is not completely square on the bottom front of the receiver. I measured from the sides of the jig out to the end of the flat in three spots on both flats to center it and they still came out uneven. Is the difference in rails acceptable for a build? I just received my ak-builder DVD but have not had a chance to watch it any advice you might be able to give me would be greatly appreciated. Thanks in advance. I have attached some photo's of the two flats after they were bent.
rigore
|
Threaded Mode
