Bolt And Auto!! Finally Here

[interceptor]

Originally Posted by kurtz

I was at Ray's today to pick up a barrel


sounds like the Phantom is working out pretty good for you.....I've been looking at getting another can, I'll have to check them out.....what is thread mounting size?

kurtz

A cut down, rechambered M1S barrel? I must have just missed you as I was dropping off my new .300 whisper donor bolt gun.


The Phantom cans we use are of the quick disconnect flavor. Work well, but a little heavy, if I decide on another centerfire can I will look into a ti model.

[kurtz]

Originally Posted by interceptor

A cut down, rechambered M1S barrel?......

That was me .......had a few of the Model 1s that we rechambered to experiment with other .30 cal cats and one that had never been fired.....took one to Ray to have the chamber cut off and shortened to 10.5"....at some point I'll re-chamber and time and torque the extension to the port, been pretty busy....

Ray said someone asked about the thread protector I was using, if it was ya'll it's the Schuster

I've got a couple thread on cans, one is a two-point type and is probably my favorite although it is a little heavier than the single point....