I came across a deal on this CZ I couldn’t refuse. A local Doctor had it built but didn’t like the group it would shoot with light bullets. It came with 1” Leupold rings and 40 rounds of Corbon 220’s. I added the bipod. I also had to pull the barrel and rethread it to 5/8X24 for my AAC 762SD. I hope to get to the range tonight to see how it shoots. Now when I get My Savage barrel from a member here Ill have 2 bolt action Whispers. I might have to sell 1 so I can get going on a AR upper.
I just got a remmi 16.75 1:8 douglas setup. haven't gotten to ther range yet... but I did make a couple test rounds 220SMKs, I woulu have gotten a CZ but funds were low. YOu have a very nice rifle. Put me third in line!
I still haven’t pulled the trigger on the CZ. I hope to get to the range tomorrow night. I caught a cold from hell and there has been some stuff come out of my nose that even scares me.
Well I finally put some rounds down range last night.
This setup is amazingly quite. At the gun all you hear is the firing pin drop and a puff of air, then the thud of the round hitting. All I had for ammo was the 220gr Corbon it came with.
Now I need to find some good glass to put on it.
Has anyone tried the Nikon with the BDC Reticle I wondered if any of the hold overs would work with 300 whisper.
How much drop is there from 100 to 200 yards?
Well I finally put some rounds down range last night.
This setup is amazingly quite. At the gun all you hear is the firing pin drop and a puff of air, then the thud of the round hitting. All I had for ammo was the 220gr Corbon it came with.
Now I need to find some good glass to put on it.
Has anyone tried the Nikon with the BDC Reticle I wondered if any of the hold overs would work with 300 whisper.
How much drop is there from 100 to 200 yards?
You can check the ballistics of your load using a ballistic calculator. I have found the one here:
works very well. 300-221 fireball (a.k.a. 300 Whisper) sub-sonic loads have very similar ballistics as a 22LR. Several people have reported pretty good success with the Pride-Fowler rapid reticle:
Keep us posted on how the Cz works out. I've built 5 rifles using the Remington 799's and they were all pretty nice but then I found the Cz and decided that is the one. I've got a rifle and just need to get to work building the barrel and suppressor. I like the lightweight and smaller action as well as the extractor and ejector system. The mag kindof sucks but you can't have it all, yet. The 700 is a nice rifle but the Cz is so much nicer.....be nice to have real info from an owner.