Quarterbore.Net Forums

		Quarterbore's Forums > Tool Topics > General Metal Lathe Discusions
newbie again

Mark Forums Read

Reply

#1

Old

03-09-2008, 05:39 PM

Rex

Rex is offline

Junior Member

Join Date: Mar 2008

Posts: 1

Question

newbie again

I have a south bend heavy 10 lathe and was wanting to know if its feasable to run a 110 volt motor on this heavy lathe? thank you

Reply With Quote

#2

Old

04-16-2008, 12:50 AM

Noel

Noel is offline

Junior Member

Join Date: Mar 2008

Location: Edmond, OK

Posts: 5

110 volts is fine.
I have a 13" and have a 2 hp 110 volt single phase motor. It was just convenient for my installation.
On 220 you could use a wall outlet but on 110 I have an RV 30 amp plug.
Noel

Reply With Quote

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 10:32 AM.