300/221 pistol upper

[tp555]

I make 30/221 bbls for a living.For over 15 years now, and have customers you would know by name.So for 30/221 bbl the ? is what length,material (SS or cromoly),gas system usually pistol gas tube and profile.This is assuming the 8"
twist for rifling.Costs are around $250 Cromo to $325 SS.Barrel blanks cost from
$150 cromo to $200 SS just for the blank so the quoted above prices aren't that bad.You get what you pay for.If you want cheaper go the model 1 or kotonics
route.If you want a cromo shorty bbl I do have stubs available.The SS stubs
are gone.I can make you a shorty ~10" or so cromo for $150 using a douglas
blank.This does not include finishing.Simple parkerising $20.Time frame about a week.There is a shortage of bbl extensions needed to make an ar barrel now.No bbl extension you can't make a barrel.I do have a few,but things are a bit screwy out there.regards.

[xxxx]

What I want is a 10" cromoly barrel. Parkerised. Pistol length gas tube, but not pistol profile. 8" twist. What is the total and where do I send the check?
Thanks, xxxx

[tp555]

PM sent. check your mail.regards.

[cherokee]

TP555;
I would like a 10" 300/221. Can you send me your contact info and address?
Thanks, Cherokee

[dflicker]

Mike Brown of Jet Suppressors can get Mike Rock barrels (1 in 8 twist) in 2-3 weeks, any lengths you want.