Powder sticking to funnel...

[too_many_hobbies]

I have a Lyman Powder Pal plastic powder funnel that I am using to precisely measure subsonic loads on an electronic scale. The problem I am having is that the powder (Hodgdon H110) sticks to the sides of the funnel requiring me to tap on the funnel for quite some time to get all the powder to release and fall down into the case. I am not sure if the problem is with the plastic being pourous or if it is a static charge issue.

Are there alternative funnels of a different type material or should I wax/coat/wipe the inside of the Lyman funnel with something to make it less pourous or to change the static charge?

I prefer this type funnel because, after zeroing out the scale with the funnel on top, I can pour and trickle powder directly into the funnel to arrive at a precise load (my scale measures to the nearest .015 grain). If required, I would consider an alternative method of arriving at the same result.

[crashnrondo]

I have the same funnel, I just had to wipe out the inside with a dryer sheet, that was over a year ago and no more problems.

Good luck
Thanks-Ron

[Artful]

Originally Posted by too_many_hobbies

I am not sure if the problem is with the plastic being pourous or if it is a static charge issue.

Right the second time - Anti-static dryer sheet - computer screen cleaning sheet - soapy water - all will change the static cling problem. If you want a funnel that doesn't do that then look for Aluminum one.

http://www.midwayusa.com/ebrowse.exe...g?brandid=1858

I have an old Pacific brand one (22-45) that works great - heck check out kitchen supply stores I think I saw a set there for cheap.