Quarterbore.Net Forums


Go Back   Quarterbore's Forums > 300 Whisper Forums > 300 Whisper Ammo and Reloading
Home Forums Classifieds Photo Server FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 09-03-2012, 11:59 PM
egraham egraham is offline
Member
 
Join Date: Oct 2008
Posts: 64
Question about expanding die

I just got to working with a new batch of brass I had made for my 300 whisper. These pieces are from once fired lc 5.56 brass that were cut down and formed but needed some final trimming.

I resized all the brass with the standard form die in my hornady 3 die set that I bought from jd jones. When I tried to trim in my forester trimmer the necks were too tight. The trimmer pilot would not go into the case mouth. I then ran all the pieces through the expander and then I had no problem trimming them to 1.350.

My question is do I need to run all the brass through the resizing die again before I load? The rounds will be 208 grain amaxs out of custom Remington 700.

Thanks. My die set is the 300 whisper custom set by hornady product # 041513c.
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:37 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2016, Jelsoft Enterprises Ltd.