300 Aac Blackout (300blk)

[BWE Firearms]

Has anyone seen this yet. From some posts buy the administrator on Silencetalk I get the impression it is a 300 Whisper.

[dflicker]

That's what it seems like. I'd like to see the reamer print.

http://300aacblackout.com/

BTW, I'm glad someone else finally caught on to using 7.62x35

http://www.quarterbore.net/forums/showthread.php?t=1108

[rsilvers]

PT&G is selling official 300 BLK reamers and headspace gauges. Forster Products is making official 300 BLK dies.

[robrob]

Looks like a really original idea they came up with. Not.

[robpiat]

Originally Posted by robrob

Looks like a really original idea they came up with. Not.

Merchandising!!!!

[TCCrewchief76]

...and may the Schwartz be with youuuuuuuuueeeeeeeeuuuuuuuuuueeeeeeeeeeeuuuuuuuuuu .....

[sha-ul]

it sure looks like a 300W, but without comparing mechanical drawings, it is hard to tell

[Scalce]

Good for them for bringing it to market.

Nobody else submitted the caliber to SAAMI.

I view this as a good thing.

[rsilvers]

If you load your own ammo, pay special attention to all of the normal safety practices. Recommended powder for most supersonic loads is Hodgdon H110.

For subsonic, there are special requirements and nearly all published loads are non-optimal for the 300 BLK upper. Many existing loads were developed for Thompson Center® single-shot pistols, or for ARs by people not aware of the magazine limitations. These loads pay no attention to automatic rifle function and should not be used. Look for a load which results in a cyclic rate of 700 rpm or more. AA1680 is recommended because its bulk density matches the case capacity and it will generate enough gas pressure to cycle the weapon.


Suggested subsonic load:

• R-P 300 AAC BLACKOUT brass
• Remington 7.5 primers
• 11.2 grains of AA 1680 powder
• Case length is 1.368 +0.000 -0.020
• Sierra 220 MK loaded to 2.089 OAL (this length is optimal for reliable feeding from USGI magazines)
• Chamber pressure 21,100 psi.

[alorton]

With a case length of 1.348" to 1.368" it sounds exactly like a 300 Whisper / 300-221 / 300 Fireball with a trim to length of 1.355". I'm assuming since they recommend AA1680 as the subsonic powder that the system uses a carbine length gas tube instead the pistol length. That is unfortunate as the pistol length has proven to be more versatile when switching back and forth between subsonic and supersonic.

As for the magazine problems caused by the bullet diameter that isn't anything new with AR shooters. I've found that a Pmag with the side rib removed is the best solution as opposed to loading ammo to a specific length. This also works well with my 7.62x40 which can't rely on overall length as the case is too long to allow such short loading.

Overall, I don't see anything new here. That said, I think it will be good for the cartridge family to have a SAAMI approved chamber and solid factory backing. I'm still waiting to see if the ammo is interchangable between the Blackout and the Whisper. From what I have read I suspect it may be.