|
Gas tube ... again! ??? HELP!
OK Guys,
Tried a pistol length gas tube from Del-Ton for my tp555 made barrel and gas block. Was too long so bend is in the wrong place to allow it to be cut.
Tried a midlength tube and cut both ends. Didn't work as the seal on the bolt carrier gas key was not good enough, so the rifle short stroked.
Got another pistol position gas tube (this time from M1S as suggested by some). Again bend is in wrong place to allow cutting the forward end.
So now I've gone through three tubes with no luck. This is getting expensive.
HELP PLEASE!!!!!
mike
|
Threaded Mode