Xebec Barrel Press:

[redleg]

trying to get a kit from him but the email is down

[THEBUG11]

Originally Posted by vladimir

I cant get the link of where to buy this press to work.Any info would be helpful .It takes me to guns network where I cant get anything to work for me even after signing up.

I like you have been looking for xebec for his tools Found him his E-Mail is xebec79407@lycos.com He'll give you a run down of what he has available. Hope this helps. THEBUG11

[Quarterbore]

I am going to be pressing a barrel tonight and I lost my directions on how to use the kit... I can figure the basics out from the thread but here is another helpful tidbit I got from the web:

The tool in the upper left hand corner is used to press the trunion on the barrel. The long "post" presses on the upper part of the trunion and the short "post" presses in the mag well area of the trunion.

The round bar in the right side of picture is used between the tool with the posts and the boom on the hydrolic press. The trick is to keep everything lined up. As you begin pressing the trunion on the barrel it tends to want to go on or slip to one side. This can lead to a few false starts.

The tool on the bottom left side of the picture holds the barrel while it is being press in. The smaller hole catches teh barrel just around the gas block. It is in that area where there is a "step" in the barrel. The larger hole is were the gas block goes through.