PMC Brass

[JonPalmer]

Has any one used PMC .223 brass to form their cases with? I was told it was to thick and would cause the gun to blow up.

Jon

[Colohunter]

So far all of the brass that I have cut down has been PMC. I measured the necks before using them, and worked up loads. So far I have not had any problems with the brass, though I only have 2-3 loadings on the brass so far.

I had just picked PMC because I had several hundred pieces laying around, so far it has not been a problem.

[WILDCATT]

just think of what was said.you can blow anything up if you use enuf exposives.PMC brass is good.GI brass is usually thicker than commercial.so you drop the charge a hair.you are going to develope your own loas so theres no problem.