What project were you working on when you decided to build a 300.

[MAG]

This is my side cocking AR-10 with:
16in 1-10 med contour stainless match barrel
4-14 MK4 leupold
I wanted a side charging AR to manually cycle subsonic rounds.I was looking for a .936 adjustable gas block when I rediscovered the 300 whisper round. That is when I decided to build a Pro Hunter just to have something different. I own two ar15's and two ar10's and several others.

I would like for other members to post their projects or gun collections here to see what members have experience with certain guns. And most important of all Why did you build a 300?

[MAG]

Two older projects.

[dick]

Originally Posted by MAG

This is my side cocking AR-10 with:
16in 1-10 med contour stainless match barrel
4-14 MK4 leupold
I wanted a side charging AR to manually cycle subsonic rounds.I was looking for a .936 adjustable gas block when I rediscovered the 300 whisper round. That is when I decided to build a Pro Hunter just to have something different. I own two ar15's and two ar10's and several others.

I would like for other members to post their projects or gun collections here to see what members have experience with certain guns. And most important of all Why did you build a 300?

Hey Mag,
I like the side cocking AR-10. Have you thought about installing an armforte ajustable gas tube to (shut in) the gas of your subsonic rounds. I have installed one on my ar-10 and ar-15. I did remove the valve from the gas tube it came on,
and reinstalled it on my original so I could position it with the hand gaurd I was using. They come set up for A2 hand gaurds.

[MAG]

I did look at the adjustable gas tubes but the idea I had for this gun was to use a 45 degree mount on the left side of the gun with burris fastfire redot site sighted in at 100yds for subsonic and manually cycle it. Then pop in a 20 round clip of supersonics and use the 4-14 to rock and roll out to 400yds. Im not trying to get it to cycle with subsonics. I was trying to go from as silent as possible(not even the sound of a bolt closing) to OH Shit ya found me.

[MAG]

I would like to see your setup. Regulating gas on semi autos has been a problem. I have the dpms sass rifle and shooting it with my cyclone is punishing with a mid-length gas system. My 16in has a rifle length and is not quite as bad.

[dick]

I use these valves to fine tune supersonic loads, as well as shut them off for subsonic loads. Both rifles have 20" barrels 15=5.56 10=.308 with standard rifle length gas systems and are set up in a DMR style. I custom installed the valves with a end mill, and as you can see the AR-10's barrel has a keyway milled into it at 12' oclock. The barrel of the AR-10 has a bit of gerth behind the gas block.

[Titleiiredneck]

I dont post my toys but I went with the whisper/blackout because originally found one cheap as hell locally after katrina and bought it. Since then I have had over 7 and currently working on a howa 1500 I had spook chamber up. Next will be either a 30hrt or a 338 whisper or 338 spectre bolt gun, possibly a switch barrel :)

[dick]

Here is a picture of my carpet. I think I am lacking in the rail department though!