Dillon form and trim die for 300 fireball using RT1200

[TCCrewchief76]

Does Dillon make these? If not, what needs to be modified to make it work?

Kevin

[hitman49]

Contact CH4D. They make the Trim die.

[TCCrewchief76]

Any idea what they are charging for that die?

[Hoser]

CH4D makes the die and it isnt expensive, under $50 if I remember, but you might need to machine off some of the toolhead to allow the chips to be sucked away.

I milled about .350 off my 1050 toolhead to make it work.

[Medic650]

You will have to machine a tool head for the hose attatchment to work. If you don't already have a RT1200, the Rapid Trim for 7.62x39 has a longer trimmer shaft and die and will work on unmodified toolhead. I beleive the 7.62x39 trim die needs to be shortened al little to trim brass to right length.

[jonblack]

Yes, CH4D. I have one and they are under $60. Yes, you have to machine the toolhead.

jonblack