Best Way To Make .300 Whisper Brass From .223 Hands Down!!!

[sgms18]

I found this on youtube. This guy has got it goin on! Only prob is now I want one! but where can I get a "trim die" to use with that Dillon rapid trim????




http://www.youtube.com/watch?v=c1FIs0FDmFQ

[Hoser]

Looks a lot like my set-up only I have a PW motor on mine and I use a universal decapping die to ensure the primer crimp gets taken care of.

CH4D makes the trim die. $50-60 if I remember.

[Fastshooter03]

Damn it that's cheating!

I like it!


Nick

[Medic650]

Depends a little on what reloader you are using. On my Dillon 550, the tool head is too thick for a cut down Dillon 308 trim die to suck chips out. Same for a C-H die. They may work on some single presses. ADillon 7.62x39 Rapid Trim will allow room on a 550 tool head to suck chips out. The 7.62x39 die needs to be shortened for a little to trim the whisper to right length too.

[wombat]

What modifications are needed to get a 1050 shaft to spin around like that?

[mstarling]

Originally Posted by wombat

What modifications are needed to get a 1050 shaft to spin around like that?

Looking at the video, I don't see the main shaft (holding the die head) moving other than up and down. The cases appear to be being indexed via movement of the shell plate as per normal with the 1050. (1050 is a GREAT press if you're loading ammo which does not require the accuracy/consistency of weighted charges.)