question for Quarterbore

[mtdew]

I'm working on a drop in magwell conversion for a m10/45 to 9mm that will use uzi mags. I saw some of your old posts about your uzi converted MAC over at uzitalk. I was wondering if you could post some pics of the bottom of the bolt.

I bought a couple of the new enhanced MPA smg bolts, but the profile does not look like it will work w/ uzi mags. However if profile on the bottom of your bolt looks the same as the mine, then apparently i'm wrong and it will work.... i'll just have to figure out how

[Quarterbore]

I am traveling for work but when I get a chance I will get you some pics...

Good luck with your project but it seems like there is not a lot of room in the M10 mag well to do do this? I'll be curious how well you make out...

[mtdew]

thanks.

as for the fit issue. The 45 magwell has room to spare compared to the uzi mag. approx .125" on each side and .240" to the rear.

since i have a adaptor that works for sten mags i *think* that this should not be that hard

sten adaptor in place


adaptor by itself